709.15 Plastic Supports for Reinforcing Steel

1. Specification:

709.15 C&MS

SS 1081

2. Sampling and/or Inspection Requirements:

Material shall conform to requirements of Supplement 1081.

The ODOT Office of Structural Engineering shall use as the basis of approval, a report, including testing procedures followed, results of tests and pictures of the samples tested submitted by the manufacturer for each specific plastic chair design.

Approved materials are listed on the laboratory's web site at http://www.dot.state.oh.us/testlab/applists/cement/plastic_supports_for_reinforcing.htm

Perform Field Inspection of the item for defects or damage after delivery to project site.

No sample required.

3. Method of Tests:

Testing of material is the responsibility of the Contractor or supplier or manufacturer of the plastic chairs. All tests are to be performed by an independent testing laboratory or as defined in Supplement 1081.