ITEM 620 DELINEATORS
620.01
Description
620.02
Materials
620.03 Layout
620.04 Removal
620.05
Installation
620.06 Method
of Measurement
620.07 Basis of
Payment
620.01 Description. This work consists of
furnishing and installing delineators, removing existing delineators for disposal,
and restoring the surface where delineators are removed.
620.02 Materials. Furnish materials conforming to:
Reflectors.................................................................
720.01
Posts,
flexible.......................................................... 720.03
Steel
hardware......................................................... 730.08
Brackets...................................................................
730.09
Stainless steel
hardware........................................... 730.10
Aluminum
hardware................................................ 730.17
Reflective
sheeting.................................. 730.192,
730.193
Delineators
consist of reflectors mounted on flexible posts or brackets. Reflectors are
reflective sheeting adhered to either a flexible post or an aluminum plate. The
colors of reflectors of each type are:
Type
C White
Type
D Yellow
Type
E Red
Delineator
reflector and flexible post color shall match that of the nearest edge line.
620.03 Layout. Lay out all delineator locations
to ensure their proper placement. The Engineer will approve the layout
before installation is started.
620.04 Removal. Remove delineators,
including reflectors, posts, brackets, and miscellaneous hardware.
The delineator becomes the property of the contractor. Remove and dispose
of concrete for delineator post embedment.
Restore
surfaces where delineator posts or concrete for embedment are removed.
620.05 Installation. Install delineators facing
traffic, except install red reflectors facing wrong-way traffic. Do not
remove the protective paper covering the face of flexible post-mounted
reflectors until after installation. Ensure that posts are not more than
1:50 out of plumb. If soil conditions may cause the post to be out of
plumb, the Contractor may drive a pilot shaft before installation.
Install
flexible posts using methods and equipment that conform to the post
manufacturer’s recommendations.
620.06 Method of Measurement. The
Department will measure Delineator by the number, including reflectors,
supports and hardware, in place, completed and accepted.
The
Department will measure Removal of Delineator, by the number.
620.07 Basis of Payment. The
Department will pay for accepted quantities at the contract prices as follows:
Item
Unit
Description
620
Each
Delineator
620
Each
Removal of Delineator