620.01 Description. This work consists of furnishing and installing delineators or reflectors, removing existing delineators for storage or disposal, and restoring the surface where delineators are removed.
620.02 Materials. Furnish materials conforming to:
Concrete, Class C or F................................................. 499
Reflectors................................................................ 720.01
Posts, flexible.......................................................... 720.03
Steel hardware......................................................... 730.08
Brackets................................................................... 730.09
Stainless steel hardware........................................... 730.10
Aluminum hardware................................................ 730.17
Reflective sheeting................................................... 730.19
Delineators consist of reflectors mounted on flexible posts or brackets. Rectangular reflectors are reflective sheeting adhered to either a flexible post or an aluminum plate. If specified, furnish reflectors separately. The colors of reflectors of each type are:
Type C Rectangular white
Type D Rectangular yellow
Type E Rectangular red
620.03 Layout. Lay out all delineator locations to ensure their proper placement. The Engineer will approve the layout before installation is started.
620.04 Removal. Remove delineators, including reflectors, posts, brackets, and miscellaneous hardware. The delineator becomes the property of the contractor. Remove and dispose of concrete for delineator post embedment.
Restore surfaces where delineator posts or
concrete for embedment are removed.
620.05 Installation. Install
delineators facing traffic, except install red reflectors facing wrong-way
traffic. Do not remove the protective
paper covering the face of flexible post-mounted reflectors until after
installation. Ensure that posts are not
more than
Install flexible posts using methods and equipment that conform to the post manufacturer’s recommendations.
620.06 Method of Measurement. The Department will measure Delineator by the number, including reflectors, supports and hardware, in place, completed and accepted.
The Department will measure Reflector by the number, including hardware, in place, completed and accepted.
The Department will measure Removal of Delineator, by the number.
620.07 Basis of Payment. The Department will pay for accepted quantities at the contract prices as follows:
Item unit Description
620 Each Delineator, Post Mounted
620 Each Delineator, Bracket Mounted
620 Each Removal of Delineator
620 Each Reflector